Application

This unit of competency defines the skills and knowledge required to prepare materials and perform routine oxy fuel gas welding of mild/low carbon steel and cast iron where the welding is not required to meet an Australian Standard or equivalent.

Where welding is required to meet AS 1554 General Purpose or equivalent codes, work health and safety (WHS) regulations and/or licensing requirements MEM05055 Weld using oxy fuel gas welding process should also be selected.

Where the interpretation of technical drawings is required unit MEM09002 Interpret technical drawing should also be selected.

Where the selection and use of engineering measuring equipment is required unit MEM12023 Perform engineering measurements should also be selected.

Where the selection and use of tools is required unit MEM18001 Use hand tools and unit MEM18002 Use power tools/hand held operations should also be selected as appropriate.

No licensing, legislative or certification requirements apply to this unit at the time of publication.

What You'll Learn

Assessment Requirements

Performance Evidence

Evidence required to demonstrate competence in this unit must be relevant to and satisfy the requirements of the elements and performance criteria on at least two (2) occasions and include:

following work instructions, standard operating procedures (SOPs) and safe work practices

cleaning and preparing materials for welding

setting up:

gas cylinders

hoses

blowpipes

tips and nozzles

regulators

flashback arrestors

selecting settings and consumables

butt and fillet weld materials to comply with specifications

cleaning welds according to SOPs.

Knowledge Evidence

Evidence required to demonstrate the required knowledge for this unit must be relevant to and satisfy the requirements of the elements and performance criteria and include knowledge of:

safe welding practices and procedures and use of personal protective equipment (PPE)

preparatory requirements

equipment and equipment settings

purpose of, and setting up requirements, of:

gas cylinders

hoses

blowpipes

tips and nozzles

regulators

flashback arrestors

fuel gas properties and applications

weld characteristics.

Assessment Conditions

Assessors must:

have vocational competency in performing routine oxy fuel gas welding at least to the level being assessed with relevant industry knowledge and experience

satisfy the assessor requirements in the Standards for Registered Training Organisations 2015 or its replacement and comply with the National Vocational Education and Training Regulator Act 2011, its replacement or equivalent legislation covering VET regulation in a non-referring state/territory as the case requires

Where possible assessment must occur in operational workplace situations. Where this is not possible or where personal safety or environmental damage are limiting factors, assessment must occur in a sufficiently rigorous simulated environment that reflects realistic operational workplace conditions. This must cover all aspects of workplace performance, including environment, task skills, task management skills, contingency management skills and job role environment skills

Conditions for assessment must include access to all tools, equipment, materials and documentation required, including relevant workplace procedures, product and manufacturing specifications

Assessment processes and techniques must be appropriate to the language, literacy and numeracy requirements of the work being performed and the needs of the candidate.

Foundation Skills

• text: This section describes those required skills (reading, writing, oral communication and numeracy) that are essential to workplace performance in this unit of competency. Foundation skills essential to performance are explicit in the performance criteria of this unit of competency.

Prerequisite Units

• {'code': 'MEM11011', 'title': 'Undertake manual handling'}
• {'code': 'MEM13015', 'title': 'Work safely and effectively in manufacturing and engineering'}
• {'code': 'MEM16006', 'title': 'Organise and communicate information'}

Parent Qualifications

• MEM30219 — Certificate III in Engineering - Mechanical Trade
  MEM
• MEM31519 — Certificate III in Engineering - Toolmaking Trade
  MEM
• MEM40119 — Certificate IV in Engineering
  MEM

Related Units

• MEM12020 — Set and operate coordinate measuring machines
  Same training package
• MEM08015 — Apply protective coatings (advanced)
  Same training package
• MEM21016 — Install and set up clocks
  Same training package
• MEM16006 — Organise and communicate information
  Same training package
• MEM16010 — Write reports
  Same training package
• MEM07015 — Set computer controlled machines and processes
  Same training package